12.2 Setting up the audit trail facility environment

This section describes how to set up the environment for the audit trail facility. Use the procedure shown in the following figure to set up the environment for the audit trail facility.

Figure 12‒3: Procedure for setting up audit trail facility environment

Each step in this procedure is described in detail in the following subsections.

Organization of this section

• 12.2.1 Normally terminating the HADB server

• 12.2.2 Preparing the directories used by the audit trail facility

• 12.2.3 Specifying server definition entries used by the audit trail facility

• 12.2.4 Starting the HADB server normally (offline mode)

• 12.2.5 Creating auditors

• 12.2.6 Enabling the audit trail facility

• 12.2.7 Defining audit targets

• 12.2.8 Changing the HADB server operation mode (To normal mode)

To Page Top