The following pages explain the online tester's operating commands. For information on command Syntax and rules, see the manual OpenTP1 Operation.

Table 5-1 lists the operating commands for running tests.

Table 5-1 List of operating commands

Command name	Function
utodbgstop	Termination of a UAP interlocked with the debugger
utodebug	Activation of a UAP interlocked with the debugger
utofilcre	Tester file creation
utofilout	Edited output of the tester file content
utols	Test status display
utomhpsvc	Service requests to an MHP
utomsgout	Edited output of send messages
utosppsvc	Service requests to an RPC interface SPP
utotrcmrg	Merger of UAP trace information
utotrcout	Edited output of UAP trace information
utoxsppsvc	Service requests to an XATMI interface SPP

Organization of this section

5.1.1 utodbgstop (termination of a UAP interlocked with the debugger)

5.1.2 utodebug (activation of a UAP interlocked with the debugger)

5.1.3 utofilcre (tester file creation)

5.1.4 utofilout (edited output of the tester file content)

5.1.5 utols (test status display)

5.1.6 utomhpsvc (service requests to an MHP)

5.1.7 utomsgout (edited output of send messages)

5.1.8 utosppsvc (service requests to an RPC interface SPP)

5.1.9 utotrcmrg (merger of UAP trace information)

5.1.10 utotrcout (edited output of UAP trace information)

5.1.11 utoxsppsvc (service requests to an XATMI interface SPP)