OpenTP1 Version 7 Tester and UAP Trace User's Guide
![[Contents]](FIGURE/CONTENT.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
(1) Syntax
utofilcre{-e test-data-definition-file-name|
-o tester-file-name|-k tester-file-kind
[-i input-data-file-name]}
|
(2) Function
Creates a tester file using the specified test data definition file or record data from the unload journal file or RPC trace data retrieved by the operating command.
(3) Options
- -e test-data-definition-file-name ~<pathname>
Specify the test data definition file that defines input data for a tester file to be created.
This option cannot be specified concurrently with the -o, -k, or -i option.
- -o tester-file-name ~<pathname>
Specify the name of a tester file consisting of data that is extracted by the operating command. When specifying this option, also specify the -k option.
The -o option cannot be specified concurrently with the -e option.
- -k tester-file-kind
Specify the kind of a tester file consisting of data that is extracted by the operating command. Specifiable file kinds are:
- RRQ
- RPC request data file
- RRT
- RPC response data file
- XRQ
- XATMI request data file
- XRT
- XATMI response data file
- XRV
- XATMI receive data file
- NRV
- Asynchronous receive message file
- SRV
- Synchronous receive message file
The operating command result data file cannot be made of data extracted by a command. Accordingly the -k option cannot specify the operating command result data file.
When specifying this option, also specify the -o option.
The -k option cannot be specified concurrently with the -e option.
- -i input-data-file-name ~<pathname>
Specify the name of an input data file that stores data extracted by the operating command. When specifying this option, also specify the -o option.
When the -o option is specified and the -i option is omitted, the standard input is assumed.
The -i option cannot be specified concurrently with the -e option.
- When the -o option is specified and the -i option is omitted, the standard input is assumed. This time, specify an input file using a pipe or redirection. When no input file is specified, the command waits for an input. To solve this, forcibly terminate the command.
- No map name is contained in mj record data of the unload journal file. When the -o option is specified to create an asynchronous receive message file or synchronous receive message file, specifying mj record data as input data assumes UTOMAP to be a map name by default.
All Rights Reserved. Copyright (C) 2006, 2010, Hitachi, Ltd.