utosppsvc service-group-name service-name RPC-request-data-file-name [RPC-response-data-file-name]

Requests an RPC interface SPP to execute a specified service. However, execution of a service cannot be requested for an SPP that expects a transactional RPC (an SPP that requires a transaction to be generated in advance at the UAP making the service request). A command error occurs if the utosppsvc command is executed for a UAP other than an RPC interface SPP.

If no reply to the service request is received within the RPC maximum reply-wait time (value specified in the watch_time operand in the system common definition), a send/receive timeout condition occurs and the command is not accepted.

This command cannot be used for a simulate MHP.

• service-group-name ~<identifier of 1-31 characters>
  Specify the name of the service group to which the service to be executed belongs.
  
• service-name ~<identifier of 1-31 characters>
  Specify the name of the service to be executed.
  
• RPC-request-data-file-name ~<pathname>
  Specify the name of the RPC request data file that contains the input data for the service request.
  
• RPC-response-data-file-name ~<pathname>
  Specify the name of the RPC response data file for storing the response data when the service is executed.
  If this command argument is omitted, the response data is deleted.
  When an existing output file is specified, its contents are overwritten. If the specified file does not exist, the online tester creates the file.