cpausrenvsetup
- Organization of this page
Function
Deletes the tabs for defining action flows and calendars from the Job Design View so as to set up or unset up the operating environment in which only items are available for use.
Format
cpausrenvsetup [-u]
Permission for execution
None
Arguments
- -u
-
Restores the setting that makes the Job Design View display the tabs for defining action flows and calendars so that the Job Design View can be used to define items.
- No option
-
Applies the setting that prevents the tabs for defining action flows and calendars from showing up in the Job Design View so that items cannot be defined from the Job Design View.
Return values
0 |
Succeeded |
58 |
Invalid argument |
111 |
An error occurred during an attempt to access the Job Design View settings file (jobdesign_config.xml).
|
125 |
System error |
Environment requirements
This command can run regardless of whether the job execution service is running or stopped.
This command can run regardless of whether the message communication service is running or stopped.
Command stored in:
install-path\bin
Note that the command is stored in the following folder by default.
- In a 32-bit operating system:
-
%ProgramFiles%\Hitachi\JP1CPA\bin
- In a 64-bit operating system:
-
%ProgramFiles(x86)%\Hitachi\JP1CPA\bin
Notes
-
If you execute this command while the Job Design View is open, the settings are enabled the next time you open the Job Design View again.
-
If this command ends abnormally, follow the instructions provided in the output error message. If the problem persists, copy the file jobdesign_config.xml.model under data-path\conf, rename it as jobdesign_config.xml, and then re-execute the command.