Preface
This manual describes JP1/Automatic Job Management System 3 - Definition Assistant (abbreviated hereafter to JP1/AJS3 - Definition Assistant).
- Organization of this preface
■ Intended readers
This manual is intended for the following persons:
-
Those who have constructed, are using, or wish to use an automated job operation system by using JP1/AJS, or who have sufficient knowledge to construct and operate a JP1/AJS system, and wish to use JP1/AJS.
-
Those who wish to use JP1/AJS3 - Definition Assistant to acquire and manage large amounts of unit definition information in a batch, or who wish to define large amounts of units in a batch.
-
Those who have a basic knowledge about Excel or have experience in operating it.
■ Organization of this manual
This manual is organized as follows:
- 1. Overview
-
Chapter 1 provides a functional overview of JP1/AJS3 - Definition Assistant, and describes examples and prerequisites for using JP1/AJS3 - Definition Assistant.
- 2. Functions
-
Chapter 2 describes the functions of JP1/AJS3 - Definition Assistant.
- 3. Installation and Setup
-
Chapter 3 describes the installation and setup procedures, and how to set up the environment setting parameters.
- 4. Operation
-
Chapter 4 describes the procedures for operating JP1/AJS3 - Definition Assistant.
- 5. Definition Items
-
Chapter 5 describes the input items displayed in the definition templates.
- 6. Troubleshooting
-
Chapter 6 describes what to do if a failure occurs in JP1/AJS3 - Definition Assistant.
- 7. Commands
-
Chapter 7 describes the commands of JP1/AJS3 - Definition Assistant.
- 8. Messages
-
Chapter 8 describes the messages output by JP1/AJS3 - Definition Assistant.
■ Reading sequence
You can select chapters in this manual to read according to your needs. We recommend you read this manual in the order shown below:
Purpose |
See: |
---|---|
To know the overview of JP1/AJS3 - Definition Assistant. |
Sections 1.1 and 1.2, and Chapter 2 |
To know about the necessary settings, including how to install and set up JP1/AJS3 - Definition Assistant. |
Sections 1.3, 1.4, 1.5, 1.6, and 1.7, Chapter 3, Chapter 7, and Appendix C |
To know the operation procedure. |
Chapter 4 |
To know about the limit values for JP1/AJS3 - Definition Assistant. |
Appendix B |
To know the contents of the definition items. |
Chapter 5 |
To know what to do if a problem occurs. |
Chapter 6 |
To know the command syntax. |
Chapter 7 |
To know the meaning of the displayed messages. |
Chapter 8 |
To know about the files and folders to be generated. |
Appendix A |
To know the meaning of the terms used in this manual. |
Appendix I |
■ Conventions: Version numbers
The version numbers of Hitachi program products are usually written as two sets of two digits each, separated by a hyphen. For example:
-
Version 1.00 (or 1.0) is written as 01-00.
-
Version 2.05 is written as 02-05.
-
Version 2.50 (or 2.5) is written as 02-50.
-
Version 12.25 is written as 12-25.
The version number might be shown on the spine of a manual as Ver. 2.00, but the same version number would be written in the program as 02-00.