16.2.5 Scheduler Service Details screen

The Scheduler Service Details screen can display status summary information about the selected scheduler service. If there is abnormality in the scheduler service, you can identify which status of the scheduler service is abnormal. If there is a factor that might stop job execution, you can display the applicable dialog box and view detailed information about the factor.

The following figure shows the Scheduler Service Details screen.

Figure 16‒5: Scheduler Service Details screen

If automatic refresh is enabled, the Scheduler Service Details screen is refreshed every 3 minutes, starting from the time that automatic refresh is enabled.

For details on the values displayed for the Suppress function and Termination restriction in Status, see ajsstatus in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference.

The Number of Jobs That Are in Queue or Running in Job Execution Status and the Number of Unreported Information Items in Retention Status of Event Jobs display the maximum values output to performance reports in the past 10 minutes. The following table shows the correspondence between the items in the Scheduler Service Details screen and the items output to performance reports.

Table 16‒3: Correspondence between the items in the Scheduler Service Details screen and the items output to performance reports

No.	Scheduler Service Details screen	the performance report output function (The ajsreport command)	Relevant section
1	Number of Jobs That Are in Queue or Running	CONTENTJOB_NUM	ajsreport in 3. Commands Used for Normal Operations in the manual JP1/Automatic Job Management System 3 Command Reference
2	Number of Unreported Information Items	EVJOB_UNREPORTED_EVENT_NUM

The Number of Execution Generations in Retention Status of Jobnets with Start Conditions displays the maximum number of execution generations monitored by the CONDGENWARNNUM environment setting parameter for the past 10 minutes. The number is updated according to the check interval specified for the CONDGENWARNINT environment setting parameter. For details on the CONDGENWARNINT and CONDGENWARNNUM environment setting parameters, see 20.4.2 Details of the environment setting parameters for scheduler services in the JP1/Automatic Job Management System 3 Configuration Guide.

When you click a desired item, the corresponding dialog box appears, in which you can view the detailed information about the clicked item. The following table lists items and what operations you can perform for them.

Table 16‒4: Items displayed in the Scheduler Service Details screen and what operations you can perform for them

No.	Item	Operation	Relevant section
1	Operating Environment button	The Scheduler Service Operating Environment dialog box appears. You can check the operating environment of the scheduler service.	16.2.8
2	Job Portal button	The List screen of the job portal appears. You can operate the units managed by the scheduler service.	15.2.3
3	number-of-jobs displayed under Job Execution Status	The Job Execution Details dialog box appears.	16.2.6
4	number-of-unreported-information-items displayed under Retention Status of Event Jobs	The Event Job Retention Details dialog box appears.	16.2.7

Cautionary note

The Number of Execution Generations in Retention Status of Jobnets with Start Conditions is updated after the time (minutes) set in the CONDGENWARNINT environment setting parameter has elapsed since the time the scheduler service was restarted or the last time it was checked. This item might display 0 until the value is updated.

To Page Top