1.6.27 Sum Up Nodes Dialog

(1) Displayed items

[Function name]

Displays the function name. If you want to change to any name, specify within 64 characters. You can use NCName definition characters of XML schema.

[Input]

Specify a node that contains the nodes that you want to sum up. If a node set is already mapped to sum up nodes function, the same is displayed.

For details about display format in [Input], see "6.4.6 Mapping Source Display Format" in "Service Platform Basic Development Guide".

[Add node] button

Displays the [Select Node] dialog. Click this button when you want to add the node that contains the nodes for sum up.

For details about the [Select Node] dialog, see "1.6.8 Select Node Dialog (Data Transformation)".

[Set Node Condition] button

Displays the [Set Node Condition] dialog. Click this button to specify a condition for the source node and allow mapping to take place only when that condition is satisfied.

For details about the [Set Node Condition] dialog, see "1.6.11 Set Node Condition Dialog". For details about to set condition in source node, see "6.7 Specifying Node Conditions" in "Service Platform Basic Development Guide".

[Remove] button

Removes the node set which was specified in [Input] from [Input].

[OK] button

Enables the specified contents and closes the dialog.

[Cancel] button

Closes the dialog without enabling the specified contents.

To Page Top

(2) Operations that can be performed in this dialog

You can set the sum up nodes function in the [Sum up nodes] dialog. For details about how to set the sum up nodes function see "6.5 Processing value or node in which function is used" in "Service Platform Basic Development Guide".

To Page Top