1.6.14 Settings for duplicate mapping range dialog
Use this dialog to specify the nodes that become copy source and copy destination (Transformation source node and Transformation destination node) at the time of copying mapping definition.
This dialog is displayed when you right click the complex content element in the Transformation source schema tree viewer on the data transformation definition screen and then select [Element name match] from [Duplicate mapping].
|
|
![[Figure]](GRAPHICS/ZS017105.GIF)
- Organization of this subsection
(1) Displayed items
- [Duplicate mapping source]
-
- [Transformation source node]
-
Specify the Transformation source node for duplicate mapping source.
To change the Transformation source node, click the [Select node] button on the right side and, specify the desired node on the [Select Node] dialog that is displayed. For details about [Select Node] dialog see "1.6.8 Select Node Dialog (Data Transformation)".
- [Transformation destination node]
-
Specify the transformation destination node for duplicate mapping source.
To change the transformation destination node, click the [Select node] button on the right side and, specify the desired node on the [Select Node] dialog that is displayed. For details about [Select Node] dialog see "1.6.8 Select Node Dialog (Data Transformation)".
- [Duplicate mapping destination]
-
- [Transformation source node]
-
Specify the transformation source node for duplicate mapping destination.
To change the transformation source node, click the [Select node] button on the right side and, specify the desired node on the [Select Node] dialog that is displayed. For details about [Select Node] dialog see "1.6.8 Select Node Dialog (Data Transformation)".
- [Transformation destination node]
-
Specify the transformation destination node for duplicate aping destination.
To change the transformation destination node, click the [Select node] button on the right side and, specify the desired node on the [Select Node] dialog that is displayed. For details about [Select Node] dialog see "1.6.8 Select Node Dialog (Data Transformation)".
- [OK] button
-
Enables the specified contents and closes the dialog.
- [Cancel] button
-
Does not enable the specified contents and closes the dialog.
(2) Operations that can be performed in this dialog
In this dialog, you can specify the nodes that will become the copy source and copy destination of mapping definition. Specify the transformation source node and transformation destination node for each item.
For details about copying mapping definition see "6.8.4 Copying mapping definition" in "Service Platform Basic Development Guide".