1.6.9 Select function dialog
Use the [Select function] dialog to specify function that will become a mapping source.
This dialog is displayed when you perform one of the following operations:
-
Click the [Add function] button in the [Settings for Mapping source] dialog
-
Click the [Add function] or [Select function] button in the settings dialog of each function
The following figure shows the [Select function] dialog:
|
|
![[Figure]](GRAPHICS/ZS016900.GIF)
- Organization of this subsection
(1) Displayed items
- [Function]
-
Displays the functions that can be selected as mapping source.
- [OK] button
-
Enables the specified contents and closes the dialog.
- [Cancel] button
-
Closes the dialog without enabling the specified contents.
(2) Operations that can be performed in this dialog
By specifying function that will become mapping source in the [Select function] dialog, you set the functions specified in the [Mapping source settings] dialog or the settings dialog of each function.