5.1 Format for describing the messages

The format for describing the messages in this chapter is as follows:

• XXXXXnnnn-Y

  Message text

  Description

  Supplementary explanation for the message text

  Action

  Action performed by the user

The description of each item is as follows:

XXXXXnnnn

This indicates a message ID.

Y

This indicates the message type.

Message text

This indicates the message contents.

The part enclosed within <> in the message indicates that the output contents might differ depending on the status during the message output or depending on the error target.

Description

This indicates the supplementary explanation such as the factors due to which the message is reported and configuration software operations that output the message.

Action

This indicates the actions performed by the user.

The format of a message ID, message type, and Message text differs depending on the type of the output message. The format for each type of output message is described from the subsection 5.1.1 onwards. Furthermore, the details about each message are described in the order of the message IDs from the section 5.2 onwards.

Organization of this section

• 5.1.1 Format of the messages (KDCCP) output by the C4Fault class

• 5.1.2 Format of the messages (KDCCE05) output by the C4Exception class

• 5.1.3 Format of the messages (KDCCE06, KDCCE9, and KDCCS30) output by the SOAP Engine

• 5.1.4 Format of the messages (KDCCR) output by the UDDI client library

• 5.1.5 Format of the messages (KDCCC) output by development support commands

• 5.1.6 Format of the messages (KDCCS1151 to KDCCS1199) output during the size check of the transmission data

• 5.1.7 Format of the messages (KDCCS1001 to KDCCS1150) output by SAAJ

• 5.1.8 Format of the messages (KDCCT0) output during the acquisition of the PRF trace

• 5.1.9 Format of the messages (KDCCT1) output by the trace functionality

• 5.1.10 Format of the messages (KDCCP30) output when using DII

• 5.1.11 Precautions

To Page Top