7.5.1 Directly starting the controller
You can directly start the controller and connect it to a remote computer without logging in to JP1/IT Desktop Management 2. Because there is no need to log in to the operation window, you can start the operation immediately if you need to perform remote control only.
To directly start the controller:
-
From the Windows Start menu, select All Programs, JP1_IT Desktop Management 2 - Manager, and then Remote Controller.
The controller starts.
At this moment, no computer is connected to. To start remote control, you must specify the connection destination. For how to specify a connection destination for the controller, see 7.5.2 Starting remote control by selecting a computer.
- Tip
-
You can also directly start the controller by executing the following command:
jdngrcctr.exe /agent IP-address
Specify the host name and IP address of the connection destination. The controller starts, and the specified computer is connected to. If you do not specify this information, the computer is not connected to.