7.3 Procedure for changing the server role from management server to management relay server
You can change the server role from either management server in a single-server system or primary management server in a multi-server system to management relay server in a multi-server system. To do so, overwrite-install JP1/IT Desktop Management 2 - Manager by selecting Management relay server as the Type of Manager to Install. Then, specify the upper management server to which the management relay server is to be connected.
- Tip
-
You cannot change the management server in a cluster environment or a computer on which JP1/IT Desktop Management 2 - Agent is installed, to a management relay server.
Note that you cannot change the Manager type when overwrite-installing a management relay server.
To change the server role from management server to management relay server:
-
On the management server that you want to change to a management relay server in a multi-server system, overwrite-install JP1/IT Desktop Management 2 - Manager. At this time, make sure that you install the same version of JP1/IT Desktop Management 2 - Manager that has already been installed on each server in the multi-server system.
Also make sure that you select Management relay server as the Type of Manager to Install when performing overwrite installation.
-
Specify the upper management server to which the management relay server is to be connected.
Now you have changed the server role from either the management server in a single-server system or the primary management server in a multi-server system to a management relay server in a multi-server system.
- Tip
-
If you want to upgrade the version of JP1/IT Desktop Management 2 - Manager when changing the role of the management server, upgrade the version, and then change the type of Manager.
- Tip
-
This tip applies when you change the management server in a single-server system to a management relay server in a multi-server system. In this case, on the primary management server in the multi-server system, you can register the product licenses that were registered on the management server in the single-server system. Note that if you want to manage product licenses on individual management relay servers in a multi-server system, execute the distributelicense command on the primary management server to set the product license information on each management relay server.
Related Topics:
-
1.3.3 Procedure for setting product license information for a management relay server
-
5.1 Procedure for performing an overwrite installation of JP1/IT Desktop Management 2 - Manager
-
3.6 Procedure for changing the higher connection destination settings of a management relay server
-
5.1 Procedure for performing an overwrite installation of JP1/IT Desktop Management 2 - Manager