7.2 Configuring an SSO cluster system environment

The following figure shows a general procedure for configuring an SSO cluster system environment.

Figure 7‒14: General procedure for configuring an SSO cluster system environment

This section describes only the Configure an SSO cluster environment step in the above general procedure.

Notes

• Configure an SSO cluster environment after you have installed cluster software and configured an NNMi cluster environment.

• When performing steps after Set up SSO, make sure that the SSO process is running in the cluster. For details about how to start the SSO process, see step 5 and the following steps in 3.1.1 Flow of SSO installation and setup tasks.

Organization of this section

• 7.2.1 General procedure for configuring an SSO cluster system environment

• 7.2.2 Configuring an SSO cluster system environment (in Windows)

• 7.2.3 Configuring an SSO cluster system environment (in Linux)

• 7.2.4 Notes on configuring the environment of an SSO cluster system

To Page Top