10.9 Product upgrade in a cluster environment
To upgrade JP1/Service Support Starter Edition operating in a cluster environment to JP1/Service Support (Standard), you need to stop JP1/Service Support first. You also need to ensure that the shared disk will have sufficient free space after the product upgrade process.
This section describes how to upgrade a JP1/Service Support Starter Edition operating in a cluster environment to JP1/Service Support (Standard).
- Notes:
-
-
If you want to upgrade JP1/Service Support from JP1/Service Support Advanced Edition to the latest version, you must perform a version upgrade installation.
Note that the version of JP1/Service Support Advanced Edition is 10-50.
-
If a JP1/Service Support version earlier than 11-00 other than JP1/Service Support Advanced Edition has been installed, you must perform an upgrade installation.
-
If you want to change the installation-destination machine when upgrading the version of JP1/Service Support, see 10.10 Replacing the installation-destination machine in a cluster environment.
- Organization of this section