10.3 Setting an environment for cluster use (migration from a physical host)
If you migrate from an existing physical host environment to a cluster environment, follow the procedure below. This procedure assumes that the primary node was in a physical host environment.
- Important
-
JP1/Service Support can migrate from a physical host environment to a cluster environment only if the product version and language settings do not change. If the versions of JP1/Service Support are different at the migration source and destination, execute the jsssetup -vup command to upgrade the physical host environment of the migration source to the same version as the migration destination.
-
On the primary node, stop the services in the following order:
-
JP1/Service Support - Task Service service
-
JP1/Service Support - Web Service service
-
JP1/Service Support service
Keep JP1/Service Support - DB Server service running.
-
-
On the primary node, execute the jssdbbackup.bat command to back up the Item management database.
From the Start menu, select Programs, JP1_Service Support, and then JP1_SS Command Prompt. Execute the jssdbbackup.bat command with the -expand option specified as an argument to back up the Item management database. For details on the jssdbbackup.bat command, see jssdbbackup.bat (backs up databases) in Chapter 12. Commands.
-
On the primary node, perform unsetup of JP1/Service Support.
From the Start menu, select Programs, JP1_Service Support, and then JP1_SS Command Prompt. Execute the jssunsetup.bat command to recover the status before setup. For details about the jssunsetup.bat command, see jssunsetup.bat (performs unsetup of JP1/Service Support) in Chapter 12. Commands.
-
Set up a cluster environment.
This step is the same as when you configure a new environment. See 10.2 Setting an environment for cluster use (environment configuration after new installation).
-
On the primary node, use the cluster software to stop the services in the following order:
-
JP1/Service Support - Task Service service
-
JP1/Service Support - Web Service service
-
JP1/Service Support service
Keep JP1/Service Support - DB Server service running.
-
-
On the primary node, execute the jssdbrecovery.bat command to recover the Item management database.
From the Start menu, select Programs, JP1_Service Support, and then JP1_SS Command Prompt. Execute the jssdbrecovery.bat command with the -expand option specified as an argument to recover the Item management database obtained in step 2. For details on the jssdbrecovery.bat command, see jssdbrecovery.bat (recovers a database) in Chapter 12. Commands.
-
On the primary node, execute the jssrefaclsetup command.
Set up the function that sets view permissions for individual Items. You can skip this step if you do not intend to use this function. For details on the jssrefaclsetup command, see jssrefaclsetup (sets up view permission settings for individual Items) in Chapter 12. Commands.