6.4.1 Overwrite installation procedure
The following describes the procedure for overwrite installation of JP1/Service Support. There are the following two kinds of overwrite installation:
-
Overwrite installation using the distribution media
-
Remote installation using JP1/NETM/DM, JP1/IT Desktop Management 2 and Job Management Partner 1/Software Distribution
The following describes the procedure for overwrite installation of JP1/Service Support using the distribution media. Administrator permissions are required to perform this procedure. For details about the procedure for remote installation using JP1/Software Distribution, see 6.3.1(2) Remote installation using JP1/NETM/DM,JP1/IT Desktop Management 2 and Job Management Partner 1/Software Distribution. If you perform overwrite installation by using remote installation, specify as the installation-destination folder the same folder set in the previous installation.
- Note
-
If you need to change the installation path after installation, uninstall the product, and then re-install the product in the desired folder.
-
Insert the distribution media into the drive, and install JP1/Service Support.
Follow the instructions of the installer which starts automatically.
The same installation-destination folder will be used as set for the previous installation.
For user information and the program names listed in the Start menu, the settings specified in the previous installation are inherited.
-
If requested, restart the operating system.