1.3.2 Settings required immediately after installation (for Windows)
If you will be changing the locale (system locale) after installation, you must set the appropriate encoding shown in the table below. Specify this setting in JP1/Base.
|
OS |
Language |
Encoding |
|---|---|---|
|
Windows |
Japanese |
SJIS |
|
Chinese |
GB18030 |
|
|
English |
C |
- Important
-
If you change the system locale while using JP1/IM - View, the behavior of JP1/IM cannot be guaranteed. When you want to change the system locale, you have to first uninstall JP1/IM, change the system locale, and then install JP1/IM again.
- Organization of this subsection
(1) How to set the encoding
-
Edit jp1bs_param.conf.
Use an editor to open the Base-path\conf\jp1bs_param.conf file, set the encoding shown in the table above in the encoding part of "LANG"="encoding".
-
Save the file, and then execute the following command with Administrator permissions:
Base-path\bin\jbssetcnf-Base-path\conf\jp1bs_param.conf
-
Start or restart JP1/Base and JP1/IM - Manager.
The settings take effect when JP1/Base and JP1/IM - Manager start. If JP1/Base and JP1/IM - Manager are already running, restart JP1/Base and JP1/IM - Manager.
- Note
-
Once you have set the encoding and started the operation, you can still use the steps above to change the encoding.