3.2.2 Setting up JP1/AJS3 - Agent

This subsection describes how to set up JP1/AJS3 - Agent. To set up JP1/AJS3 - Agent, you must have administrator privileges.

Make sure that JP1/Base has already been set up before you attempt to set up JP1/AJS3 - Agent.

Note that this subsection describes the basic setup of JP1/AJS3. If you need to change the settings to match specific operating requirements, see the appropriate section listed in the following table.

Topic	Reference
Procedure for setting environment setting parameters	4.2
Procedure for restricting connections to JP1/AJS3	21.2.1
Settings for defining the work path to be used during job execution as a variable	6.2.1
Settings for executing a job with a long file name	6.2.15
Settings for executing jobs that require a user profile	6.2.16
Changing the settings related to the size of the log for event jobs to match operational requirements	6.3.1
Setting the status passing option for the file monitoring job	6.3.3
Settings for large-file monitoring (monitoring of files that are 2 GB or larger)	6.3.16
Settings for executing a job that requires a user profile in a queueless job environment	6.4.2
Settings for the JP1/AJS3 definition pre-check function	6.5.1
Settings for logging	7
Setting up for a cluster system	8

Organization of this subsection

(1) Setup procedure

(1) Setup procedure

To set up JP1/AJS3 - Agent:

If necessary, change the account settings for the JP1/AJS3 service.

Skip this step if it is not necessary to change the account settings for the JP1/AJS3 service. For details about the operation required to change the account settings, see 4.2.3(1) Changing the account for services provided by JP1/AJS3 in the JP1/Automatic Job Management System 3 System Design (Configuration) Guide.
If necessary, change the environment setting parameters.

Skip this step if you accept the environment setting parameter values proposed by JP1/AJS3. To change environment setting parameter values, use the jajs_config command, or the jbssetcnf command provided by JP1/Base.

For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference. For details on the jbssetcnf command, see the JP1/Base User's Guide.
If necessary, set up the system and user environments.

For details about setting up the system and user environments, see 3.5 Setting up the system and user environments.

JP1/AJS3 - Agent setup is complete.

To Page Top