4.2 Environment setting parameter settings
This section describes how to change common definition information that has already been registered.
You can use the following methods to change the common definition information that has already been registered:
-
jajs_config command
If you use the jajs_config command, you can eliminate specification errors because the specified environment setting parameter names and values are checked.
With the jajs_config command, you can set the environment setting parameters that have the same definition key at the same time. To set environment setting parameters that have different definition keys, run the jajs_config command for each definition key.
For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual JP1/Automatic Job Management System 3 Command Reference.
-
jbssetcnf command
If you use the jbssetcnf command provided by JP1/Base, the new environment setting parameter settings specified in a setting file will replace the corresponding current settings.
With the jbssetcnf command, you can set multiple environment setting parameters at the same time even if one or more parameters have different definition keys. For details about the jbssetcnf command, see the JP1/Base User's Guide.
Note that the parameter names and values provided by the jbssetcnf command are not checked. If you specify any settings that are incorrect, you might want to restore the previous settings. For details about how to restore the previous settings when incorrect settings have been registered, see B. Recovery Procedure Used When an Incorrect Environment Settings Parameter is Set.
For details about the environment setting parameter settings necessary for registration in the common definition information, see 20. Environment Setting Parameters.
The following describes how to use each method.