6.3.3 Setting the status passing option for the file monitoring job
While the file monitoring job is monitoring target files, the monitoring information can be saved continuously so that the monitoring status of the job can be inherited if the JP1/AJS3 service temporarily stops.
Note that the monitoring status can be inherited only if the file monitoring job is operating continuously. Whether the monitoring status can be inherited depends on whether the file monitoring job is operating continuously.
For details about the conditions under which the monitoring status can be inherited, see 7.6.2 Notes on the Monitoring Files job in the JP1/Automatic Job Management System 3 System Design (Work Tasks) Guide.
The function that inherits the monitoring status of the file monitoring job is disabled by default. Note, however, that the function is enabled when JP1/AJS3 is installed as a new installation and set up. The following describes how to set the status passing option.
- Organization of this subsection
(1) Definition procedure
-
In Windows Control Panel, open the Services administrative tool, and stop the following service:
-
JP1/AJS3 service
-
-
Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k definition-key "parameter-name"=value
-
Restart JP1/AJS3.
The new settings are applied.
(2) Environment setting parameter
|
Definition key |
Environment setting parameter |
Explanation |
|---|---|---|
|
[{JP1_DEFAULT|logical-host}\JP1AOMAGENT]# |
"FilewatchinfContinue"= |
Specifies whether the status passing option for the file monitoring job is enabled. |
- #:
-
The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of this environment setting parameter, see 20.6.2(20) FilewatchinfContinue.