8.1 JP1/AO system migration procedure (to an environment with the same host name or IP address)

To migrate a JP1/AO system to an environment with the same host name or IP address , you must perform a backup and restore operation.

Prerequisites

The following items must match on the original server and the target server:
- Host name
- IP address
- System locale
- The environment for Hitachi Command Suite products (configuration, version number, revision number, and restriction code)
- JP1/AO installation folder
- JP1/AO installation folders for databases
No tasks must be in the In Progress, Waiting for Response, Abnormal Detection, or Terminated status on the original JP1/AO server.
JP1/AO must not be installed on the target server.

The following describes the migration procedure depending on whether the original JP1/AO server has been upgraded.

Table 8‒1: Migration procedure
Task		Reference
1	Back up JP1/AO on the original server.	For non-cluster systems: Backing up data in JP1/AO (non-cluster configuration) in the JP1/AO Administration Guide For cluster systems: Backing up data in JP1/AO (Windows cluster configuration) or Backing up data in JP1/AO (Linux cluster configuration) in the JP1/AO Administration Guide
2	Install JP1/AO on the target server.	For non-cluster systems: 1.1 New installation procedure For cluster systems: 5.1 Procedure for installing JP1/AO in a cluster system
3	Restore JP1/AO on the target server.	For non-cluster systems: Restoring data in a JP1/AO system (non-cluster configuration) in the JP1/AO Administration Guide For cluster systems: Restoring the JP1/AO system (Windows cluster configuration) or Restoring the JP1/AO system (Linux cluster configuration) in the JP1/AO Administration Guide
4	Make sure that the target server is running, and then start operations.	--