6.6.5 Procedure for changing resource settings (Linux)

To change resource settings:

1. Use the cluster software to move resource groups that are registered in JP1/AO to the active server.

2. If JP1/AO is upgraded from a version earlier than 11-10, check whether the version of cluster service control commands and the version of model files are the same. If the model files have been upgraded, re-create the cluster service control commands.

   For the procedure for re-creating cluster service control commands, see 5.7.1 Tasks required before the cluster service control commands can be registered.

3. Use the cluster software to bring the resource group offline.

4. Use the cluster software to re-enable starting, stopping, and monitoring the resources other than the following resources:

   • Shared disk

   • Logical host name

   • Logical IP address

   If JP1/AO is upgraded from a version earlier than 11-10, review resources that have been registered in resource groups and set resource dependencies.

   For the procedure for setting resource dependencies, see 5.3.7 Procedure for using the cluster software to register resources and to set up the resource group (in Linux).

5. Use the cluster software to bring the resource group online.

6. Log in to the product as a user who has the Admin role and execute the importservicetemplate command to import the JP1/AO - Contents service templates or Service Template Set into JP1/AO.

7. If necessary, apply updates to the components used in the service template and changes to the service template to the service.