4.7.2 Deleting the Tasks

The following shows the procedure for deleting the Probe Daemon's task definitions and the IE Probe Daemon's task definitions by using PFM - Web Console.

1. From the monitoring console browser, log on to PFM - Web Console.

   The main window of PFM - Web Console appears.

2. In the navigation frame of the main window, choose the Services tab.

   The Services window appears.

3. In the navigation frame of the Services window, expand the contents of the monitoring agent host folder, and select the Agent Collector service.

   The Properties page appears.

4. Expand the hierarchy under the Probe folder, and select the ADD OR DELETE A TASK.

5. Set properties appear at the bottom of the information frame.

   Specify the values of the properties listed in the following table None is set by default.

   Property name	Specifiable value
   Delete A Task	Specifies the task from the drop-down list. When you delete a task, you must specify the task.

   Reference note:

   Use the New Task ID and the New Task Protocol property to add a new task (you can delete an existing task and add a task at the same time). Since the Reserved property is reserved for the system, you cannot use it.

6. In the bottom of the information frame, click the OK button.

   When succeeding in deleting the task, the task status becomes "Deleted". The deleted task remains in the Task List tree until its deletion is applied to the Probe Daemon and the IE Probe Daemon. The deleted task folder in the Task List tree disappears when its deletion is applied. You cannot add the task specifying the same task ID of the deleted task until its deletion is applied to the Probe Daemon and the IE Probe Daemon. For details about how to apply information to the Probe Daemon and the IE Probe Daemon, see 4.7.4 Applying the Task information.

To Page Top