9.2 List of commands

1

9.4 jslmdbcopy (backs up database)

Mgr

Backs up the database used in SLM.

2

9.5 jslmdbrstr (restores database)

Mgr

Restores the database used in SLM.

3

9.6 jslmmgrconfig (setting a monitored service)

Mgr

Sets the monitored service.

4

9.7 jslmmgrconnect (connecting SLM - Manager)

Mgr

Requests a connection from the master instance of SLM - Manager to the slave instance of SLM - Manager to be connected to.

5

9.8 jslmmgrdbcleanup (cleans up database)

Mgr

Deletes unneeded data, including data that remained when monitored services were deleted and data that was created when database errors occurred.

6

9.9 jslmmgrexport (exports service monitor information)

Mgr

Exports service monitor information needed for data migration.

7

9.10 jslmmgrimport (imports service monitor information)

Mgr

Imports service monitor information that was exported by the jslmmgrexport command.

8

9.11 jslmmgrls (confirming the system management status of SLM - Manager)

Mgr

The system management status of SLM - Manager is displayed in the window of the command prompt.

9

9.12 jslmmgrsetup (sets up SLM - Manager)

Mgr

Creates an execution environment for SLM - Manager.

10

9.13 jslmmgrunsetup (undoes SLM - Manager setup)

Mgr

Discards the execution environment for SLM - Manager.

This command is used when the settings specified during setup are to be changed without uninstalling SLM - Manager.

11

9.14 jslmminfoget (collects data needed for investigating the cause of SLM - Manager errors)

Mgr

Collects error information for SLM - Manager and information needed for error analysis.

12

9.15 jslmreport (outputs report data to a CSV file)

Mgr

Outputs report data stored in the database to a CSV file.

13

9.16 jslmurinfoget (collects data needed for investigating the cause of SLM - UR errors)

UR

Collects error information for SLM - UR and information needed for error analysis.

14

9.17 jslmuripls (displays network interface number and IP address)

UR

Displays in the command prompt window the network interface number and IP address of the host on which SLM - UR is installed.

The information displayed by this command is needed for setting up SLM - UR.

15

9.18 jslmurnals(displays the network adapter address and IP address)

UR

The network adaptor address and IP address of the host on which SLM - UR is installed is displayed in the window of the command prompt.

The content displayed upon executing this command will be necessary when setting up SLM - UR.

16

9.19 jslmursetup (sets up SLM - UR)

UR

Creates an execution environment for SLM - UR.

17

9.20 jslmurunsetup (undoes the SLM - UR setup)

UR

Discards the execution environment for SLM - UR.

This command is used when the settings specified during setup are to be changed without uninstalling SLM - UR.