5.1.12 Undoing the SLM - UR setup
You must undo the SLM - UR setup before you can set up SLM - UR again.
When setup is undone, the settings in the system definition files that have been edited by the user are initialized. Before you unto setup, be sure to back up the system definition files, if necessary.
For details about backing up the system definition files, see 8.1.1 Backing up the definition files.
This subsection explains how to undo the setup of SLM - UR.
- Organization of this subsection
(1) Before you start
Verify that setup of SLM - UR whose setup is to be undone has been completed.
Terminate the SLM - UR whose setup is to be undone.
For details about the termination method, see 2.1.3 Terminating SLM - UR.
(2) Procedure
To undo the SLM - UR setup:
Execute the unsetup command.
Execute the following unsetup command:
SLM-UR-installation-folder\ur\bin\jslmurunsetup
For details about the unsetup command, see 9.20 jslmurunsetup (undoes the SLM - UR setup) in 9. Commands.
When the command terminates normally, undoing of the SLM - UR setup is complete.