8.1.1 Backing up the definition files
The following are the SLM definition files:
System definition files: jp1itslm.properties and jp1itslmur.properties
System configuration properties file: system_config.properties
You must back up these definition files manually.
This subsection explains how to back up the definition files.
We recommend that you always back up the system definition files after you have edited them.
- Organization of this subsection
(1) Before you start
Verify that setup of the applicable SLM - Manager or SLM - UR has been completed.
For details about how to set up SLM - Manager, see 5.1.6 Setting up SLM - Manager; for details about how to set up SLM - UR, see 5.1.7 Setting up SLM - UR.
(2) Procedure
To back up the definition files:
Copy the definition files to a desired location.
Copy the following definition files:
- Definition files for SLM - Manager:
![[Figure]](GRAPHICS/F0000029.GIF)
SLM-Manager-installation-folder\ mgr\conf\jp1itslm.properties SLM-Manager-installation-folder\ mgr\sdpengine\analysisN#\conf\system_config.properties#: N is a number from 1 through 10.
- Definition files for SLM - UR:
- SLM-UR-installation-folder\ ur\conf\jp1itslmur.properties SLM-UR-installation-folder\ ur\sdpengine\collector\conf\system_config.properties SLM-UR-installation-folder\ ur\sdpengine\collector2\conf\system_config.properties SLM-UR-installation-folder\ ur\sdpengine\recorder\conf\system_config.properties
When you have finished copying the definition files, the task of backing up the definition files is complete.
(3) Supplementary information
You can back up the definition files regardless of whether SLM - Manager or SLM - UR services are running.