3.3.1 Installing JP1/Base
To install JP1/Base:
-
Quit all programs.
Be sure to quit all JP1 programs, and all programs that are currently accessing the JP1/Base event service, before you install JP1/Base.
-
Run the Hitachi Program Product Installer.
Install JP1/Base as prompted by the Hitachi Program Product Installer. For the operation steps, see 3.3.2 Using the Hitachi Program Product Installer.
For a new installation, the Installer sets up and initializes JP1/Base automatically so that JP1/Base is ready for operation immediately after installation completes.
The following items are set when you select automatic setup:
For details on each item, see 8.3 User management setup (in UNIX).
At execution, the Hitachi Program Products Installer automatically installs the Hitachi Network Objectplaza Trace Library (HNTRLib2). The installation folder is /opt/hitachi/HNTRLib2/.
- Remote installation of JP1/Base (software deployment) through JP1/NETM/DM,JP1/IT Desktop Management 2 and Job Management Partner 1/Software Distribution:
-
JP1/Base supports remote installation through JP1/NETM/DM,JP1/IT Desktop Management 2 and Job Management Partner 1/Software Distribution. JP1/Base allows you to perform the following types of installation:
-
Installation of a new program
You can install a new JP1/Base program in the target host.
-
Upgrade to a newer version
You can upgrade an existing JP1/Base program to a newer version on the target host through remote installation.
See JP1/NETM/DM, JP1/IT Desktop Management 2 or Job Management Partner 1/Software Distribution Manual for more information.
Be sure to use a JP1/NETM/DM 09-00 or later packager, a JP1/IT Desktop Management 2 packager or a Job Management Partner 1/Software Distribution 09-00 or later packager to package this software product.
JP1/NETM/DM is sold only in Japan.
-