1.3 Search procedure
The asset management system enables you to total and search for managed asset information to best suit your goals.
This section describes the procedures for specifying search conditions to search for asset information and for executing various processing by using the search results. The following figure shows the search procedure and the window location that corresponds to each step.
|
|
![[Figure]](GRAPHICS/ZU070400.GIF)
-
From the job menus, select the type of work you wish to execute (such as Device List).
The window for the selected job type is displayed.
-
Using a simple search condition or by clicking the Browse button, select a desired group or location.
You can easily specify a search condition by selecting a desired group or location from the appropriate tree. Use the tabs to switch between the group and location trees.
To clear a specified condition, click the icon on the top of the tree.
If divisions have been assigned to the login user, selecting the Group tab displays the assigned division names and division group names in the tree. If you wish to specify a division in a condition, select the corresponding division name and division group name from the tree. The Group and Division radio buttons are displayed in the Group field. Note that when you select Division, the Browse button is disabled. Select a desired division name and division group name from the tree to specify the search conditions.
-
Specify other search conditions, in addition to a group or location.
The possible search conditions depend on the job type. If you specify multiple search conditions, they are treated as being joined by logical AND.
-
Click the Search button.
A listing of the search results is displayed.
You can output the search results as a CSV file.
- Organization of this section