11.3.3 Link with other systems in a multiple-monitoring environment
When linking with other JP1 products in a multiple-monitoring environment, you must specify the same settings on the primary Manager and the secondary Manager.
The following describes settings for each linkage product.
- Organization of this subsection
(1) When linking with JP1/IM
The settings when linking with JP1/IM are the same as those when multiple monitoring is not configured. For details, see 12. Linking with the Integrated Management Product JP1/IM for Operation Monitoring.
- Important note
-
When two PFM - Manager services are linked to one JP1/IM service, reports might not be displayable from JP1/IM. For details, see 17.3.8 A connection from the time the JP1/IM's Event Console starts monitoring to PFM - Web Console cannot be established.
(2) When linking with JP1/ITSLM
The settings when linking with JP1/ITSLM are the same as those when multiple monitoring is not configured. For details, see 13. Performance Monitoring Linked with JP1/IT Service Level Management (JP1/ITSLM).
- Important note
-
Only one PFM - Manager service can be linked per JP1/ITSLM service. Even if the primary Manager goes down, service monitoring in JP1/ITSLM can continue because performance information continues to be sent from PFM - Agent and PFM - RM. However, you cannot perform operations for Performance Management such as starting or stopping of monitoring from JP1/ITSLM. Therefore, when the primary Manager goes down, you must change the connection target to the secondary Manager.
(3) When linking with NNM
The settings for displaying reports from NNM must be specified on either the primary Manager or the secondary Manager. For details, see 14.2.3 Setup for linking with NNM.