11.3.2 Installing and setting up programs
- Organization of this subsection
(1) Installation and setup
Install and set up PFM - Manager and PFM - Web Console. Install and set up the programs in the same way as you would when not configuring multiple monitoring. For details, see the chapter that describes installation and setup (for Windows) or installation and setup (for UNIX) in the Job Management Partner 1/Performance Management Planning and Configuration Guide.
(2) Settings that must be done before duplicating definition information
You must set the following items before you can duplicate definition information. Set the following information on both the primary Manager host and the secondary Manager host.
-
The following information in Table 11-2 Definition information for which the same setting must be specified on the primary Manager and the secondary Manager
-
Host information configuration file (jpchosts)
-
Setting of Authentication mode
-
Health check function
-
Status monitoring function
-
Product name display function
-
IPv6 communication
-
-
The information in Table 11-3 Definition information that must be matched in jpccomm.ini
- Important note
-
Match the settings between the primary Manager and the secondary Manager.