2.11.4 Setting up JP1/IT Desktop Management on the primary server
This subsection describes the setup views that require settings that are needed to run cluster systems.
- Important note
-
On a computer that runs Windows 8, do not specify the following folders during installation:
-
Folders under system-drive:\program files\WindowsApps
-
Folders in storage areas created by virtual provisioning
-
Settings in the Cluster Environment view
In the Cluster Environment view for setup, specify the settings needed to run a cluster system. The following figures show the Cluster Environment view.
Do the following:
-
Select Use Cluster configuration to operate IT Desktop Management - Manager.
-
Select Primary.
-
Set Logical host name and Logical IP address.
For this operation, you do not need to set Setting file to import.
When setup finishes the following, file is output. Copy this file to the standby server.
JP1/IT Desktop Management-installation-folder\mgr\conf\jdn_manager_setup.conf
Settings in the Folder Settings view
In the Folder Settings view for setup, specify the settings needed to run a cluster system. The following figure shows the Folder Settings view.
Enter the path to the shared disk in the following items:
-
Database folder
-
Data folder
In the following views, enter the path to the shared disk in following items:
-
Operation log database in the Operation Log Settings view (when recording an operation log)
-
Operation log backup folder in the Automatic Backup Setting for Operation Logs view (when specifying a folder on the local disk as the folder for storing the operations log)
-
Output folder for the revision history in the Output Settings for Saving the Revision History view (when specifying a folder on the local disk as the folder for storing revision histories)
For other items, use the normal setup procedure.
Related Topics: