2.4.3 Procedure for setting up a management server for a multi-server configuration system
To build a management server for a multi-server configuration system, setup the management server as soon as the custom installation of JP1/IT Desktop Management - Manager finishes.
Before you can build a management server, a database server must have been built. Also, during database server setup, set the folder specified in Data folder as a shared folder that can be accessed from the management server.
- Important note
-
On a computer that runs Windows 8, do not specify the following folders during installation:
-
Folders under system-drive:\program files\WindowsApps
-
Folders in storage areas created by virtual provisioning
-
To set up a management server:
-
From the Windows Start menu, select All Programs, JP1_IT Desktop Management - Manager, Tools, and then Setup.
-
In the Setup view, click the Next button.
-
In the Select a Setup view, select the setup type, and then click the Next button.
This view dose not appear in the initial setup after installation.
-
In the Server Configuration Settings view, select Multi-server configuration and Single-server configuration, and then click the Next button.
-
In the Cluster Environment view, specify whether to use a cluster environment, and then click the Next button.
If you are using a cluster environment and select Secondary, skip steps 6 and 7, and go to step 8.
-
In the Folder Settings view, specify the data folder that will be used by JP1/IT Desktop Management, and then click the Next button.
-
In the Settings for the Data Folder Shared Between Servers view, specify the database server and the shared folder, and then click the Next button.
-
In the Confirm Setup Settings view, make sure the setup information is correct, and then click the Next button.
Setup is executed. If you notice a problem, click the Back button and make the necessary correction.
-
In the view indicating that setup is complete, click the OK button.
Setup is complete, and the management server starts operation with the specified settings.
Related Topics: