1.13.2 Notes on restarting JP1/AO services

When you restart a JP1/AO service, a task might fail depending on the task status when the service was stopped. The following table describes how tasks behave when a JP1/AO service restarts.

Table 1‒23: Task behavior after a JP1/AO service restarts
No.	Task status when the JP1/AO service stops	Task behavior after the JP1/AO service restarts
1	Waiting	If the system restarts before the scheduled start time: The task remains in the waiting status. If the system restarts after the scheduled start time: The tasks starts executing immediately.
2	Holding	The task remains in the being held status.
3	Now running	The task fails.
4	Waiting for Response	The task fails.
5	Abnormal Detection	The task fails.
6	Terminated	The task fails.
7	Completed	The task remains in the ended normally status.
8	Failed	The task remains in the failed status.
9	Canceled	The task remains canceled.

To Page Top