1.12.2 Configuring JP1/AO to reference authentication information of connection destination definitions
You can configure JP1/AO to reference authentication information specified in connection destination definitions when it executes a service.
The procedure and the timing for the configuration vary depending on the type of plug-ins you are using.
Basic plug-ins
For the following basic plug-ins, specify destination in the credentialType property when you create or edit a step. If you specify property in the credentialType property, the authentication information setting for connection destination definitions is not referenced because the property value of the plug-in is referenced. For details about how to set properties, see the related topics section for each plug-in in the manual Job Management Partner 1/Automatic Operation Service Template Reference.
-
General command plug-in
-
File-forwarding plug-in
-
Terminal connect plug-in
Content plug-ins
When you use the Create Plug-in dialog box to create a content plug-in, or use the Edit Plug-in dialog box to edit a content plug-in, select Destination in the Credentials Type area. If you select Property in this area, the property value of the plug-in is referenced rather than the authentication information setting for connection destination definitions.