6.2.7 Setting up the logical host in the active system (ITSLM - UR)

You set up ITSLM - UR as the logical host in the active system.

You can set up either ITSLM - UR first or ITSLM - Manager first.

Organization of this subsection

(1) Before you start

Before you start the setup, install the ITSLM - UR that is to be set up.

For details about how to install ITSLM, see 6.2.5 Installing ITSLM.
Verify that the following Windows service is stopped:
- ITSLM - UR service JP1/ITSLM - User Response Service (service name: JP1_ITSLM_UR_Service)

The other items to be verified are the same as when ITSLM is run in a non-cluster system; for details, see 5.1.7 Setting up ITSLM - UR.

To set up the logical host in the active system:

Execute the command for checking the network interface number and IP address of the host on which ITSLM - UR has been installed.

Execute the following command:

ITSLM-UR-installation-folder\ur\bin\jslmuripls

For details about the command for checking the network interface number and IP address, see jslmuripls (displays network interface number and IP address) in 9. Commands.
Create the options file required for setup based on the information checked by executing the jslmuripls command.

For details about the options file, see jslmursetup (sets up ITSLM - UR) in 9. Commands.
Store the created options file in a desired folder.

Make sure that the absolute path of the options file storage location does not exceed 255 bytes including the options file name (any name).
Execute the setup command.

The following shows the setup command that is to be executed:

ITSLM-UR-installation-folder\ur\bin\jslmursetup -c online absolute-path-of-options-file

For details about the setup command, see jslmursetup (sets up ITSLM - UR) in 9. Commands.

If the command terminates normally, ITSLM - UR has been set up to be used as the logical host in the active system.

The supplementary information is the same as when ITSLM is run in a non-cluster system; for details, see 5.1.7 Setting up ITSLM - UR.