6.2.6 Setting up the logical host in the active system (ITSLM - Manager)
You set up ITSLM - Manager as the logical host in the active system.
You can set up either ITSLM - Manager first or ITSLM - UR first.
This subsection explains how to set up ITSLM - Manager.
- Organization of this subsection
(1) Before you start
-
Before you start the setup, install the ITSLM - Manager that is to be set up.
For details about how to install ITSLM, see 6.2.5 Installing ITSLM.
-
Verify that the following three Windows services have stopped:
-
ITSLM - Manager service JP1/ITSLM - Manager DB Cluster Service (service name: HiRDBClusterService_JL0)
-
ITSLM - Manager service JP1/ITSLM - Manager Service (service name: JP1_ITSLM_MGR_Service)
-
ITSLM - Manager service JP1/ITSLM - Manager Web Service (service name: JP1_ITSLM_MGR_Web_Service)
-
The other items to be verified are the same as when ITSLM is run in a non-cluster system; for details, see 5.1.6 Setting up ITSLM - Manager.
(2) Procedure
To set up the logical host in the active system:
-
Create the options file required for setup.
For details about the options file, see jslmmgrsetup (sets up ITSLM - Manager) in 9. Commands.
-
Store the created options file in a desired folder.
Make sure that the absolute path of the options file storage location does not exceed 255 bytes including the options file name (any name).
-
Execute the setup command.
The following shows the setup command that is to be executed:
ITSLM-Manager-installation-folder\mgr\bin\jslmmgrsetup -c online absolute-path-of-options-file
For details about the setup command, see jslmmgrsetup (sets up ITSLM - Manager) in 9. Commands.
If the command terminates normally, ITSLM - Manager has been set up to be used as the logical host in the active system.
(3) Supplementary information
The supplementary information is the same as when ITSLM is run in a non-cluster system; for details, see 5.1.6 Setting up ITSLM - Manager.