Following table describes definition items:

Table 6-35 TableRoundObjectsDefinition item

Item name	Definition contents	Value that you can define	Additional description
Name	Function name	Value of NCName type	This is mandatory item. You cannot define the Name in Objects, in duplication.
Input	Input	See "6.12.2 Setting up the mapping definition"	-
Type	Round node types	Either of "off", "down", or "up"	This is mandatory item. In case of "off" Set up "Round" as Round node type. In case of "down" Set up "Round down" as Round node type. In case of "up" Set up "Round up" as Round node type.

(Legend)

-: Corresponding item does not exist.

Following figure shows the definition example:

Figure 6-74 FigureRoundObjectsDefinition example