Note the following points when you set up Remote Management:

• If you start the J2EE server from a WTP connector, the settings managed by the management portal will overwrite the settings of the J2EE server. Therefore, do not edit usrconf.cfg and usrconf.properties directly to change the J2EE server settings. Use the management portal to edit usrconf.cfg and usrconf.properties.
• When operating the J2EE server from the WTP connector, log in to the Connection Host of Remote Management.
• If the J2EE server is being displayed in the Server view, do not delete the Connection Host corresponding to that J2EE server.