Requirements for remote installation to security PCs

Job Management Partner 1/Software Distribution Administrator's Guide Volume 2

Appendix B.1 Requirements for remote installation to security PCs

For update data to be remotely installed to security PCs, the conditions described below must be satisfied.

Organization of this subsection: (1) Manager; (2) Packager; (3) Relay manager/system; (4) Security PC

(1) Manager

The manager is JP1/Software Distribution Manager version 07-00 or later for Windows (uses a relational database) or JP1/Software Distribution Manager Embedded RDB Edition version 07-50 or later.
The manager uses a host ID to operate the JP1/Software Distribution system.
The manager is connected to the security PCs through a network, and the security PCs are registered in the system configuration information.

(2) Packager

Packager is the Packager of JP1/Software Distribution version 08-00 or later for Windows.

(3) Relay manager/system

When remotely installing update data to security PCs via a relay manager, the relay manager must be JP1/Software Distribution Manager version 07-00 or later for Windows (uses a relational database) or JP1/Software Distribution Manager Embedded RDB Edition version 07-50 or later.
When remotely installing update data to security PCs via a relay system, the relay system must be JP1/Software Distribution SubManager version 06-72 or later for Windows.

(4) Security PC

Use the system launcher to specify the manager or relay manager/system in the higher connection destination system to be used for remote installation.

All Rights Reserved. Copyright (C) 2009, 2013, Hitachi, Ltd.
Copyright, patent, trademark, and other intellectual property rights related to the "TMEng.dll" file are owned exclusively by Trend Micro Incorporated.