The following steps show how to terminate and start the managing server in a cluster system environment in which Embedded RDB is used as the relational database:

1. Place the following generic-service resources offline:
   
   • Asset Information Synchronous Service^#
   • Microsoft Internet Information Services^#
   • Remote Install Server
2. Execute the netmdb_stop.bat command that is stored in JP1/Software-Distribution-Manager-installation-directory \BIN. Check the message to make sure that Embedded RDB has terminated.
3. Place the generic-service resource HiRDB/ClusterService_JN1 offline.
4. Execute the jamemb_dbstop.bat command that is stored in JP1/Software-Distribution-installation-directory\jp1asset\exe.^#
   Check the message to make sure that Embedded RDB has terminated.
   
5. Place the generic-service resource HiRDB/ClusterService_AM1 offline.^#
6. Use the cluster system administrator to move the group and set the owner as the standby server.
7. Shut down the OS on the active server.
8. Shut down the OS on the standby server.
9. Start the OS on the standy server.
10. Start the OS on the active server.
11. Use the cluster system administrator to move the group and set the owner as the active server.
12. Place the following generic-service resources online:
    
    • HiRDB/ClusterService_AM1^#
    • HiRDB/ClusterService_JN1
    • Remote Install Server
    • Microsoft Internet Information Services^#
    • Asset Information Synchronous Service^#

#: Required when Asset Information Manager Subset is used.

While you are operating the system in a cluster system environment in which Embedded RDB is used as the relational database, if you wish to restart the OSs on the active server and the standby server, do the following steps:

1. Place the following generic-service resources offline:
   
   • Asset Information Synchronous Service^#
   • Microsoft Internet Information Services^#
   • Remote Install Server
2. Execute the netmdb_stop.bat command that is stored in JP1/Software-Distribution-Manager-installation-directory \BIN. Check the message to make sure that Embedded RDB has terminated.
3. Place the generic-service resource HiRDB/ClusterService_JN1 offline.
4. Execute the jamemb_dbstop.bat command that is stored in JP1/Software-Distribution-installation-directory\jp1asset\exe.^#
   Check the message to make sure that Embedded RDB has terminated.
   
5. Place the generic-service resource HiRDB/ClusterService_AM1 offline.
6. Use the cluster system administrator to move the group and set the owner as the standby server.
7. Place the following generic-service resources online:
   
   • HiRDB/ClusterService_AM1^#
   • HiRDB/ClusterService_JN1
   • Remote Install Server
   • Microsoft Internet Information Services^#
   • Asset Information Synchronous Service^#
8. Restart the OS on the active server.
9. On the standby server, perform steps 1 through 5.
10. Use the cluster system administrator to move the group and set the owner as the active server.
11. Place the following generic-service resources online:
    
    • HiRDB/ClusterService_AM1^#
    • HiRDB/ClusterService_JN1
    • Remote Install Server
    • Microsoft Internet Information Services^#
    • Asset Information Synchronous Service^#
12. Restart the OS on the standby server.