If you change the JP1/Software Distribution Manager settings in a cluster environment while you are using an Embedded RDB relational database, you must use the procedure described below to change settings for both the active server and the standby server.

To change settings for the active and standby servers:

1. Delete the Registry Copy setting for the generic-service resource for Remote Install Server.
2. Place the following generic-service resources offline:
   
   • Remote Install Server
   • Asset Information Synchronous Service^#
   • Microsoft Internet Information Services^#
3. Execute the netmdb_stop.bat command that is stored in JP1/Software-Distribution-Manager-installation-directory \BIN.
   Check the message to make sure that Embedded RDB has terminated.
   
4. Place the generic-service resource for HiRDB/ClusterService_JN1 offline.
5. Change the JP1/Software Distribution Manager setup.
6. Execute the netmdb_setup.bat command that is stored in JP1/Software-Distribution-Manager-installation-directory\BIN.
   The KFPS01863-E message appears in the command prompt window. However, this appears because the generic service HiRDB/ClusterService_JN1 is placed offline and does not cause any problem.
   
7. Execute the netmdb_stop.bat command that is stored in JP1/Software-Distribution-Manager-installation-directory \BIN.
   Check the message to make sure that Embedded RDB has terminated.
   
8. Place the following generic-service resources online:
   
   • HiRDB/ClusterService_JN1
   • Remote Install Server
9. Start Remote Installation Manager.
   Make sure that Remote Installation Manager can start.
   
10. Exit the Remote Installation Manager.
11. Place the generic-service resources for Remote Install Server offline.
12. Execute the netmdb_stop.bat command that is stored in JP1/Software-Distribution-Manager-installation-directory \BIN.
    Check the message to make sure that Embedded RDB has terminated.
    
13. Place the generic-service resource for HiRDB/ClusterService_JN1 offline.
14. Use the cluster system administrator to move the group and set the owner as the standby server.
15. On the standby server, perform steps 5 through 13.
16. Use the cluster system administrator to move the group and set the owner as the active server.
17. Place the following generic-service resources online:
    
    • HiRDB/ClusterService_JN1
    • Microsoft Internet Information Services^#
    • Asset Information Synchronous Service^#
    • Remote Install Server
18. Enter the Registry Copy setting for the generic-service resource for Remote Install Server.

#: This step is required if Asset Information Manager Subset is used.

How to rename a host after operation has begun

To rename a logical host, you must use the Logical host name option on the Cluster Settings page in the setup according to the procedure described in Changing the setup configuration, regardless of the type of database.

If you are using an Embedded RDB database and rename a logical or physical host, you must edit various definition files. For details about the definition files that must be edited and how to edit them, see 7.3.1(1) Renaming the host after operation has started in the manual Setup Guide.