Note the following items when using HP OpenView Linkage:

• You cannot use the HP OpenView linkage functionality if you have linked JP1/Software Distribution to JP1/Base and you are using the user management facility.
• To enable the agent address of SNMP trap, you must specify -W in the start option of the ovtrapd process of HP NNM so that WinSNMP is disabled. To specify -W in the start option:
  
  1. Close all HP NNM windows.
  2. Stop the HP NNM service.
  3. Execute the following commands from the MS-DOS prompt (example when HP NNM is installed on C drive):
     cd C:\OpenView\lrf
     ovdelobj ovtrapd.lrf
     notepad ovtrapd.lrf (starts Notepad)
     
  4. Add the -W option to the last line of the ovtrapd.lrf file opened by Notepad and save the file.
     Add -W between pmd and OVs_WELL_BEHAVED as follows:
     OVs_YES_START:pmd:-W:OVs_WELL_BEHAVED::
     
  5. Execute the following command from the MS-DOS prompt:
     ovaddobj ovtrapd.lrf
     
  6. Start the HP NNM service.
• Before starting the HP NNM service, choose Administrative tools and Services from the Control Panel and stop SNMP Trap Service.
• To display the HP NNM IP map correctly, be sure to specify All Levels in On-demand: To what level should submaps be persistent. You can specify an IP Map by choosing Properties from the Map menu of HP NNM.