Use this page when an AIT file will be used during remote installation. This page is displayed only when the package type is Other companies' software.

Figure 2-25 AIT File page

Wait for the completion of AIT file processing

Specify whether or not monitoring for a response from installation processing that uses the AIT file is to be performed.

If the client user responds to a dialog box or uses the keyboard or mouse during installation, the installer's window display may differ from what the AIT file is expecting, halting the remote installation using the AIT file. In such a case, to prevent the installation process from being aborted, you can interrupt the installation process if no response is received within a specified amount of time

Time-out

If you select the Wait for the completion of AIT file processing option, specify the maximum amount of time monitoring for a response from the AIT file is to be performed. The permitted value range is 1-21,600 seconds (360 minutes or 6 hours). Normally, you should set a value that is approximately three times the amount of time required to install the distributed software. The default is 5 minutes.