Job Management Partner 1/Software Distribution Setup Guide

[Contents][Glossary][Index][Back][Next]

Appendix D.3 Setting up the JP1/Software Distribution Network Node Manager Linkage

To set up the JP1/Software Distribution Network Node Manager Linkage:

  1. Log in as a superuser.
    Make sure that the background process of HP NNM version 7.5 or earlier is started.
  2. Execute the /opt/NETMDM_NNM/bin/dmnnm_install command.
    This command registers files required for registering JP1/Software Distribution symbols and menus in HP NNM.
  3. Execute the /opt/NETMDM_NNM/bin/dmnnm_setup -s command.
    The following screen appears. Choose (2) Setup.
    # dmnnm_setup -s
    ** JP1/Software Distribution NNM Linkage Setup **
    The host name or IP address of the OpenView Linkage Gateway Server to be connected
    Current setting: [ ]
    1)*Next
    2) Setup
    3) Cancel
    - > 2
    Specify the host name or IP address of the OpenView Linkage Gateway Serve to be connected.
    - > dmp195
  4. Specify the host name or IP address of the OpenView Gateway Server.
    Specify the host name or the IP address of the OpenView Gateway Server to be connected to HP NNM, then press the Enter key. The following screen appears.
    The port number used to connect the OpenView Linkage Gateway Server
    1)*Next
    2) Setup
    3) Cancel
    - > 2
    Specify the port number used to connect with the OpenView Linkage Gateway Server.
    - > 20049
  5. Specify the port number that should be used for communication with the OpenView Gateway Server.
    Specify the port number that should be used when an attempt to access JP1/Software Distribution management information is made from HP NNM. Use the port number that should be set during setup for the OpenView Gateway Server. When you press the Enter key, the following screen appears.
    * Set the following items. *
    The host name or IP address of the OpenView Linkage Gateway Server to be connected:
    [ dmp195 ]
    The port number used to connect with the OpenView Linkage Gateway Server:
    [ 20049 ]
    1)*Apply the Setup
    2) Cancel
    - > 1
    Setup completed.
    #
  6. Confirm the specified values.
    When you choose Apply the Setup, the specified values will be applied to the configuration file.

[Contents][Back][Next]

[Trademarks]

All Rights Reserved. Copyright (C) 2009, 2013, Hitachi, Ltd.
Copyright, patent, trademark, and other intellectual property rights related to the "TMEng.dll" file are owned exclusively by Trend Micro Incorporated.