On the Task page, in Run, specify -s TARGET=(change-log-code-to-be-deleted) following the file name. You can specify multiple codes.

If nothing is specified, the task deletes only the change log for asset information.

Codes for the change log that can be deleted are as follows:

• A
  Asset information history. The affected class is AssetUpdateRecord.
  
• U
  Update history. The affected classes are UpdateRecord and InstalledUpdateRecord.
  

If you specify multiple codes, specify them consecutively, such as -s TARGET=AU.

On the Task page, in Run, specify the value following the file name in the format shown below:

• Change log for asset information
  -s TARGET=A -s MONTH=(retention-period)
  Specify the retention period in number of months (0-120). Specifying 0 deletes all change log information.
  If nothing is specified, the task deletes all change log data that is at least six months old.
  
• Device change log
  -s TARGET=U -s UMONTH=(retention-period)
  Specify the retention period in number of months (0-120). Specifying 0 deletes all change log information.
  If nothing is specified, the task deletes all change log data.
  

Specification example

This example deletes the logs of asset information that were acquired more than 3 months ago.

"C:\netmdm\jp1asset\exe\jamscript.exe"

-f "C:\jp1asset\scriptbatch\RemoveRecord.txt"

-s TARGET=A -s MONTH=3

Here, C:\netmdm\jp1asset refers to the Asset Information Manager Subset installation folder.