The following notes apply to creation of system configuration information:

• You can create a maximum of seven hierarchical levels in the system configuration information.
• To create a relay system in the system configuration, you must create under the relay system a client with the same name as the relay system that has the address selected by the node identification key (host name or IP address). Do not move the client under the relay system that has the same name as the relay system that was created.
• If you execute remote installation or a Get user inventory information job on a UNIX relay system, you must define in the system configuration information a client with the same host name under the UNIX relay system, and then specify this client as the destination of the job.