Job Management Partner 1/Asset Information Manager Planning and Setup Guide
This section describes the procedures for using Windows Task Scheduler to enable and disable tasks, change a task execution schedule, and delete tasks.
By default, all Asset Information Manager tasks created in Windows Task Scheduler are disabled. To use a task, you must enable it. You can disable any task that you are not using.
In addition, to use a task in a 64-bit OS, see F(2) Notes on executing commands and tasks in a 64-bit OS.
To enable or disable a task registered in Task Scheduler:
The table below shows the Run setting for each task.
The notations AIM and Windows in the table correspond to the following folders:
Table 5-27 Run setting for each task
Task name | Run setting |
---|---|
Data maintenance | "AIM\exe\jamscript.exe" -f "AIM\scriptbatch\DataMaintenance.txt" |
Notification of invalid contract information | "Windows\system32\cscript.exe" "AIM\exe\jamexpiration.vbs" |
Notice of license excess | "Windows\system32\cscript.exe" "AIM\exe\jamLicenseOver.vbs" |
Totals number of licenses | "Windows\system32\cscript.exe" "AIM\exe\jamSoftwareAddUp.vbs" |
Notification of unauthorized install | "Windows\system32\cscript.exe" "AIM\exe\jamPermitInstall.vbs" |
Delete change log | "AIM\exe\jamscript.exe" -f "AIM\scriptbatch\RemoveRecord.txt" -s TARGET=A -s MONTH=6 |
Take inventory | "AIM\exe\jamTakeDMInventory.bat" |
Take operation history | "AIM\exe\jamscript.exe" -f "AIM\scriptbatch\TakeClientOperation.txt" |
Acquiring directory information | "AIM\exe\jamscript.exe" -f "AIM\scriptbatch\DMDirectory.txt" |
Take node information | "AIM\exe\jamTakeNodeData.bat" |
Synchronization of WSUS at user-specified timing | "AIM\exe\jamscript.exe" -f "AIM\scriptbatch\SyncUpdates.txt" |
Notification of WSUS updates | "AIM\exe\jamscript.exe" -f "AIM\scriptbatch\ScanNewUpdates.txt" |
You can change a task's execution date and time. You can also add a schedule.
To delete an unneeded task:
You can check the execution results of a task in the Scheduled Tasks window that is displayed when the Scheduled Tasks icon is double-clicked.
Set the Scheduled Tasks window to the detail view and check the return value that is displayed in Last Result. For details about the displayed information, see ASTMESn.log.
For the return values and their descriptions, see the description of each task in 5.9.1(1) Name and details of each task.
All Rights Reserved. Copyright (C) 2009, 2011, Hitachi, Ltd.