Job Management Partner 1/File Transmission Server/FTP Description, Reference and Operator's Guide
You create a definition file as shown below and then specify host names.
- Organization of this subsection
- (1) Creating a definition file
- (2) Contents of the definition file
- (3) Notes
(1) Creating a definition file
Create a definition file with the following path name:
JP1/FTP-installation-directory\FTPHOSTACC.INF
(2) Contents of the definition file
Use a text editor to specify the definition file (FTPHOSTACC.INF) according to the following method:
Begin by specifying a definition name, and then specify values on the following lines. If you specify multiple values, make sure that you specify only one value on each line. Any characters following a hash mark (#) through a linefeed are treated as a comment.
The following table lists and describes the definition names and values that can be specified.
Table 3-11 Definition names and values that can be specified in the definition file (FTPHOSTACC.INF)
Definition name Description Value [allow_list] Specifies hosts whose connection is to be permitted. IP address or host name [deny_list] Specifies hosts whose connection is to be rejected. IP address or host name
- Example
(3) Notes
- If there is no definition file, connection is permitted from all hosts.
- If there is a definition file but it does not contain any valid definitions, connection requests from all hosts are rejected.
- A connection request from a host that is not specified in the definition file or a host that is specified in both [allow_list] and [deny_list] is rejected.
All Rights Reserved. Copyright (C) 2010, Hitachi, Ltd.