Job Management Partner 1/File Transmission Server/FTP Description, Reference and Operator's Guide

3.11 Using JP1/FTP in a multiple IP address environment

In an environment in which multiple IP addresses can be used, such as an environment that uses multiple NICs or a cluster environment, the following functions are available:

Function that enables you to specify the local IP address of the FTP client
Setting the local address for the FTP client's source address is enabled by defining YES in the FTP client definition and specifying the logical host name in the API, in an argument of the ftstran command, or in the input field for the client host name in a custom job.

Function for setting the FTP server host name in a response message sent by the FTP server to the address that accepted the connection
Specifying the connected IP address or the host name obtained by converting the connected IP address as the FTP server's host name in a response message that is sent from the FTP server is enabled by defining either YES or NO in the FTP server definition.

Function for specifying the destination of JP1 events
Sending to a specified host the JP1 events that report start and stop of services (FTP client, FTP server, log, or agent) is enabled by defining the logical host name or logical IP address in the JP1 event definition.

These functions take effect after the definition file is created, and then each service is started.

Organization of this section

3.11.1 Creating a definition file

[Contents][Back][Next]

[Trademarks]